Mandown Alarm Feature (MySOS Mandown variant only)
The MySOS Mandown variant of the device contains a mandown sensor which
enables the device to automatically send an alarm to Skyguard IMC if it detects
a rapid movement followed by an impact. This feature can be useful in instances
when the user slips, trips, or falls, and therefore may not be able to raise an
alarm manually.
The mandown feature must be specied as enabled or disabled by the customer
when placing the order, prior to the device being despatch. The device can
be setup either with mandown permanently enabled, or manually switched on/
off when required from within Skyguard’s CSC portal. Please check with your
administrator or Skyguard Customer Support to establish if this feature has been
enabled on your device.
The mandown feature should be enabled only when the device is being worn
in a holster or ID badge holder accessory and securely attached to the user, in
order to prevent false alarms.
If you raise a mandown alarm to Skyguard’s IMC by mistake, please inform the
Controller as soon as the call is answered, by saying “Activation call, activation
call”. The Controller will ask questions based on your user details to conrm that
it is not an emergency and will then end the call.
- 12 -
To Next Page
Loading...