HB600-24B CHARGER MANUAL 06JAN2009
- 3 –
Safety: General
• Do not operate a charger that is not working correctly. An electric shock
hazard or battery explosion hazard from overcharging may exist.
• Do not attempt to service the charger yourself unless you are a trained
service technician. The warranty is void if the charger case has been
opened. Always follow installation instructions closely. The high voltages
inside the charger are a shock hazard and can cause serious injury or
death.
• Though the charger is resistant to water and spray washing do not fully
immerse or spray wash for an extended (more the 5 seconds in one
position) time. Liquid can get inside charger and may cause serious injury
or death.
• The charger is designed for use in industrial areas. It is not designed to be
used in medical (hospital) environments where interference with life critical
equipment could cause death or serious injury.
• There could be a spark during charging. Be careful when using fuels,
solvents or other flammables near the charger or batteries. An explosion
could result causing death or serious injury.
• The charger surface can get hot while operating and contact with the skin
or surrounding materials should be avoided.
Safety: Power
• To reduce the risk of an electric shock, connect only to a properly grounded
single-phase (3wire) outlet.
• Ensure that the AC voltage supplied to the charger is within the ranges in
the specification table. Voltages outside this range, particularly high
voltages, can result in an electric shock and fire hazard.
• If you use an extension power cable with your charger, ensure the total
current draw of the items plugged into the extension power cable do no
To Next Page
Loading...
Need help?
General