SKYJACK, Page 12 SJIII Series
Section 1 - Scheduled MaintenanceOperator’s Responsibility for Maintenance
Safety Precautions (Continued)
Know and understand the safety precautions before going on to next section.
• DO NOT exceed the rated capacity of the
aerial platform. Do make sure the load is evenly
distributed on the platform.
• DO NOT attempt to free a snagged platform with
lower controls until personnel are removed from
the platform.
• DO NOT position the aerial platform against
another object to steady the platform.
• DO NOT place materials on the guardrails or
materials that exceed the confines of the guardrails
unless approved by Skyjack.
Fall Protection
As per the ANSI A92.6-2006 standard, “The guardrail
system of the aerial platform provides fall protection.
If occupant(s) of the platform are required to wear
personal fall protection equipment (PFPE), occupants
shall comply with instructions provided by the aerial
platform manufacturer (remanufacturer) regarding
anchorage(s).”
If additional fall protection is required, by an employer or
the authority having jurisdiction, Skyjack recommends
the use of a fall restraint system to keep an occupant
within the confines of the platform, and thus not expose
the occupant to any fall hazard requiring a fall arrest.
All personal fall protection equipment must comply
with applicable governmental regulations and must
be inspected and used in accordance with the
manufacturer’s recommendations.
All personal fall protection equipment must be attached
only to approved anchorage points within the platform
of the aerial platform.
WARNING
Entering and exiting the aerial platform
should only be done using the three
points of contact.
• Useonlyequippedaccessopenings.
• Enterandexitonlywhentheaerial
platform is in the fully retracted position.
• Dousethreepointsofcontacttoenterandexit
the platform. Enter and exit the platform from
the ground only. Face the aerial platform when
entering or exiting the platform.
• Threepointsofcontactmeansthattwohands
and one foot or one hand and two feet are in
contact with the aerial platform or the ground at
all times during entering and exiting.
WARNING
An operator should not use any aerial
platform that:
does not appear to be working properly.•
has been damaged or appears to have worn or •
missing parts.
has alterations or modifications not approved by •
the manufacturer.
has safety devices which have been altered or •
disabled.
has been tagged or blocked out for non-use or •
repair.
Failure to avoid these hazards could re-
sult in death or serious injury.
Jobsite Inspection
Do not use in hazardous locations.•
Perform a thorough jobsite inspection prior to •
operating the aerial platform, to identify potential
hazards in your work area.
Be aware of moving equipment in the area. Take •
appropriate actions to avoid collision.
To Next Page
Loading...
Need help?
General
