Page 22 December 2007
SJ 86T
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the MEWP.
FAMILIARIZATION
2.3-5 Engine Compartment
- Ensure all compartment latches are secure
and in proper working order.
• Main Power Disconnect Switch
- Turn main power disconnect switch
to “ ” off position.
- Ensure there are no loose or missing
parts and there is no visible damage.
- Ensure all cables are secure and switch
is in proper working condition.
• Batteries
Proper battery condition is essential to good
engine performance and operational safety.
Improper uid levels or damaged cables and
connections can result in engine component
damage and hazardous conditions.
WARNING
Explosion hazard. Keep flames and
sparks away. Do not smoke near
batteries.
WARNING
Battery acid is extremely corrosive -
Wear proper eye and facial protection as
well as appropriate protective clothing.
If contact occurs, immediately ush with
cold water and seek medical attention.
1. Check battery cases for damage.
2. Clean battery terminals and cable ends
thoroughly with a terminal cleaning tool or
wire brush.
3. Ensure all battery connections are tight.
4. If applicable, check battery uid level. If plates
are not covered by at least 13 mm (1/2”) of
solution, add distilled or demineralized water.
5. Replace battery if damaged or incapable of
holding a lasting charge.
WARNING
Use original or manufacturer-approved
parts and components for the MEWP.
Engine Compartment
Main Power Disconnect Switch
Battery
Engine
Air Filter
MuferHydraulic
Pumps
Visual & Maintenance Inspection Section 2 - Familiarization