Skyteam ST50-3TR - Idle Speed and Throttle Operation; Idle Speed Adjustment; Throttle Operation and Cable Care

IDLE SPEED
Idle speed:
The engine must be at normal operating
temperature for accurate idle speed
adjustment.Ten minutes of stop-and-go riding is
sufficient.
Do not attempt to compensate for faults in other
systems by adjusting idle speed.See your
SKYTEAM dealer for regularly scheduled
carburetor adjustments.
1.Warm up the engine and hold the motorcycle
upright.
2.Connect a tachometer to the engine.
3.Adjust idle speed with the throttle stop
screw(1).
Idle speed(In neutral):
1,350  100min-1(rpm)
(1)Throttle stop screw (A)Increase
(B)Decrease
(1)
A
B
51
THROTTLE OPERATION
Cable Inspection:
1,Check for smooth rotation of the throttle grip
from the fully open to the fully closed position
at both full steering positions.
2.Inspect the condition of the throttle cable from
the throttle grip down to the carburetor. If the
cable is kinked,chafed or improperly routed,it
should be replaced and/or rerouted.
3.Lubricate the cable with a commercially
available cable lubricant to prevent premature
wear and corrosion.
(1)Throttle cable
(1)
52