The high pressure brake is used by disc brake
system. To ensure the safety, the replacement
interval of oil pressure line and brake fluid should
not be more than that stipulated in
"MAINTENANCE SCHEDULE" of this
manual.
Before riding the motorcycle, be sure to check
daily the following items:
(1) Check the front and rear brakes system
for leakage of brake fluid.
(2) Check the oil pressure line for leakage of
fluid or tears.
(3) Check the brake lever and brake pedal for
free play.
(4) Check the front and rear brakes lining for
wear.
NOTICE
When the new brake lining begins to be used,
don't ride your motorcycle immediately after
the replacement. Apply the brake, release it,
then spin the wheel and check that it rotates
freely. Repeat this procedures several times and
allow the brake fluid to circulate normally.
WARINING
>
11
CLUTCH
Clutch adjustment may be required if the
motorcycle stalls when shifting into gear or tends
to creep;or if the clutch slips,causing acceleration
to lag behind engine speed.Minor adjustments
can be made with the clutch cable adjuster (4) at
the lever (1).
Normal clutch lever free play is:
10-20mm (0.4-0.8in)
(1) Clutch lever
1.Pull back the rubber dust cover (2).
2.Loosen the lock nut (3) and turn the adjuster
(4). Tighten the lock nut (3) and check the
adjustment.
3.If the adjuster is threaded out near its limit or
if the correct free play cannot be obtained,loosen
the lock nut (3) and turn in the cable adjuster (4)
completely.Tighten the lock nut (3) and install
the dust cover.
(2) Dust cover (A)Decrease free play
(3) Lock nut (B)Increase free play
(4) Clutch cable adjuster
12
To Next Page
Loading...