1. Lay one Straight Tube (5) with foam and one Curved
Tube (6) with foam (8) on the ground, insert the Straight
Tube(5) into the curved tube(6), secure with the screw(4).
Repeat this step to attach the seven remaining Straight
Tubes(5) and Curved tubes(6) together (not shown).
2，Inspect the attachments of the enclosureNetting to the
trampoline mat (bed). Make certain each of the V-rings on
the trampoline mat (bed) is threadedthrough the
corresponding “buttonhole” in the Netting.Besuretoplacethe
door openinginthe enclosure net-tingsoitiscenteredin
between the two legs of the trampoline where
the jumpers will climb off and onto the trampoline
easily as shown.
ENCLOSURE ASSEMBLY
4
6
5
1
2
Make sure that you understand the information in the
box at the top of page 13.
18
To Next Page
Loading...
