DISASSEMBLY (TAKING APART)
To disassemble (take apart) the trampoline, follow assembly steps 1 through 11 in reverse order. Do not attempt to
disassemble any frame parts before the springs and the mat have been removed. Use gloves to protect your hands
from pinch points while taking the trampoline apart.
Safety Note: Do not use the trampoline without the
Frame Pad. The Frame Pad comes in 2 pieces. The Frame
Pad is designed to reduce the possibility of injuries due to
jumpers coming in contact with the trampoline frame. If
you do not have a Frame Pad, contact your dealer to
obtain one. Properly install the Frame Pad before using
the trampoline.
Secure the corners of the Frame Pads to the frame
using the attached straps. Hook the straps to the D-rings
at each corner.
11. Using the included plastic tie, attach the Safety Placard
to the frame near the enclosure opening.
The trampoline is now fully assembled. Make sure that
all parts are securely attached. Familiarize yourself and
all users of the trampoline with the safety precautions,
use and instructional materials, and care and maintenance
instructions in this manual before using the trampoline.
10.
10.
11.
Look underneath the trampoline. Locate the straps
attached to the underside of the frame pad. Position each outer
strap so that one strap is on each side of the frame as shown.
Tie the outside straps sewn to the Pad Joints to each side of the frame
as shown and attach the inner straps to the near V-rings.
Repeat this step with the remaining straps (not shown).
17
To Next Page
Loading...
