6
SYSTEM MENU
·Power supply menu, user can choose battery type(2S~6S) to make sure goggles show real capacity
of the battery
·Voltage calibration gives user ±0.9V range to adjust the voltage, when calibrate the voltage, use
multimeter to measure the loaded voltage of the battery, then use shuttle wheel to adjust voltage.
·RSSI Calibration: use can calibrate the RSSI in this menu, to calibrate the RSSI, user need remove the
antenna, and turn off the VTX, then select yes, when calibration is done, the goggle will beep.
·System Language can select in to: English,Chinese .
·Time and Date: User can adjust the time and date of the monitor，Press REC button to quit setting.
F ：User can adjust the fan speed，16 stage to adjust.· an
·Factory Reset: User can reset the settings to factory reset.
·VRX Update: User can update the VRX firmware when copy the firmware to the SD card.
·DVR Update: User can update the DVR firmware when copy the firmware to the SD card.
Monior firmware， Firmware，Serial Number will shown at this menu.·System Version : DVR
Display
· In Display setting menu, customer can set the topbar OSD time, disable OSD time out, the OSD always on.
·I n Display menu, adjust the vertical position of the RSSI.
·The Luminance of the screen and be adjust in the menu (8 stage, default is 5).Normally do not
set the brightness too high unless the image is dim.
· .In Display setting menu, customer can change the aspect ratio(4:3 or 16:9)
1,Connect monitor to the computer.
2,Hold the wheel then turn on the monitor, the usb cable will power the goggles, release the wheel,
computer will automatically install the driver , computer will show a new removable storage .
3, copy the Firmware(A/B) File to storage . monitor will installing the update at the same time.
DVR
1,Take a SD card and format the card to FAT32.
2,Copy the DVR Firmware to the SD card , insert it in the goggles and turn it on.
3,Go to the system menu and choose DVR FM upgrade.
Receiver Firmware
1,Connect monitor to the computer.
2,Hold the wheel then turn on the monitor, the usb cable will power the goggles, release the wheel,
computer will automatically install the driver , computer will show a new removable storage .
3, copy the receiver firmware to storage . receiver will installing the update at the same time.
Firmware Update
Monitor
This content is subject to change, download latest version from:
www.skyzonefpv.com
To Previous Page
Loading...
