TECH SPECS
* (0-35 PSI, Standard Tire: P195/65 R15)
TIRE INFLATION TIME 8 min*
CFM (LPM) 0.49 CFM (13.9 LPM) @ 0 PSI
DIAL GAUGE PSI 0-60, BAR 0-4
12V POWER CORD LENGTH 10 . (3 m)
POWER SOURCE 12V accessory power outlet
TOTAL REACH 12 . (3.6 m)
Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A
CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death
could occur. Always operate the inflator in a well-ventilated area free of combustible materials,
gasoline, or solvent vapors. Always set parking/emergency brake and ensure vehicle is in Park
(or neutral if equipped with manual transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle’s engine running to
achieve the optimal inflator performance. Never start a vehicle with the inflator plugged
into the DC 12 Volt power socket.
• Do not aempt to disassemble inator.
• No user serviceable parts inside. The only user serviceable part is the replaceable fuse.
• Keep inator out of reach of children.
• Place inator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper ination.
• DO NOT use inator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inator unaended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inate.
• So inatables (i.e. ras, balls, etc.) may not have recommended pressure markings. Be
careful not to inate items beyond their capacity.
• While operating, never block the inator input or output.
• For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp
cigaree lighter receptacles.
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS EXTREMELY
DANGEROUS. ALWAYS ALLOW FOR PROPER VENTILATION.
To Next Page
Loading...
