5. PICKLEBALL SPEED DIAL: Controls the speed of the pickleballs being fired. The launcher speed
ranges from the lowest speed of 10mph/16kmph to an advanced player speed of 45mph /
73kmph.
6. SPIN RATE DIAL: Controls the spin of the pickleballs. Spin Rate range is -3 (maximum under spin) and
3 (maximum top spin). Point the dial to FLAT for flat balls.
7. FEED RATE DIAL: Controls the feed rate of the balls. Feed Rate range is between 2-7 seconds.
8. LAUNCHER BEEPS (SPEAKER): A series of “BEEP” sounds can be heard when operating the
launcher as follows:
a. Short Beep: When switching the Launcher to ‘ON’ on the control panel.
b. Short Beep: Whenever pressing the Remote Control “ON” or “OFF”.
c. Long Beep: 5 to 10 seconds after pressing the Remote Control launcher button to ‘ON’,
indicating that the feeder plate has started to rotate.
d. Short Beep: Whenever pressing the Remote Control Launcher button to “OFF”.
9. LAUNCHER MANUAL ON/OFF SWITCH: Allows you to operate the launcher manually, in the event
that you have lost or misplaced the remote. To turn ON the launcher, press and hold the button for 3
seconds. To turn it OFF, press the button once.
10. OSCILLATOR* CONNECTOR: Magnetic Plug to connect to the Oscillator cable.
11. OSCILLATOR MANUAL ON/OFF SWITCH: Allows you to operate the oscillator manually, in the event
that you have lost or misplaced the remote. Press the button once to turn oscillator ON and OFF.
12. OSCILLATOR* LED: Indicates when the Oscillator is ‘On’ after pressing the Oscillator remote button
or activating Oscillator manually.
SLINGER BAG LAUNCHER CONTROLS (CONTINUED)
19
Slinger Bag User Guide - Pickleball 2/2023
IMPORTANT
It is highly recommended to always operate the Slinger Bag using the provided
remote control for safety reasons. Please make sure not to misplace the remote.
In exceptional circumstances, such as if the remote is lost, refer to the above
instructions to operate the launcher without the remote control.
USER NOTE
The top speed can only be reached in FLAT mode (and not when spin knob is set to
either TOP or UNDER spin).
To Next Page
Loading...