Machine
SAFETY
GETTING STARTED
Always begin your session by making sure your Oneline glides freely
through the center of the bar by pulling in the Oneline trim and releasing
it. The best time to do this is when someone is holding your kite in the
position where you are ready to launch and all five lines are taught. Pull in
the Oneline trim and release it. If it flows freely you are ready to launch.
P 10
ONELINE RELAUNCH SAFETY
INSTANT DEPOWER
Oneline technology features the safest
depower system in the market with
Instant Depower. There are two ways
to activate Instant Depower. Use your
bungee leash to connect yourself to the
bar and either unhook from the chicken
loop and let go of the bar or pull the
red safety handle connected to the Clip
& Ride. The Oneline is connected to
the leading edge which allows your
kite to flip into a position that depowers
your kite 100%. Let your kite fall to the
ground/water/snow, and then prepare
to relaunch or reboot your Clip & Ride if
the safety system was pulled.
After releasing the Clip & Ride:
If you pull the Clip & Ride safety
system, the Oneline will immediately
kill all power to the kite. To retrieve
the bar, use a hand over hand
technique to pull yourself to the bar.
Make sure the Oneline is cleated in
the Oneline trim cleat with three or
more feet of Oneline cleated off to
prevent unwanted relaunch. If you
pulled the Clip & Ride quick release
and the Oneline is cleated off, now
is the best time to reboot the Clip &
Ride system. You are now ready to
relaunch.
To Next Page
Loading...
