INFLATION
STEPS
1. Close the OUT valve and secure with Velcro straps.
2. Make sure valve clip for each strut is open.
3. Clip the pump leash to the leash loop on the leading edge (LE) of the kite.
4. Insert pump nozzle into IN valve and secure with a slight twist.
5. Inflate kite to 6-8 psi. In constant air temperatures above 85° F / 30° C, inflate
only to 6 psi. This is due to air expansion in higher temperatures.
6. Pull pump nozzle and secure valve with Velcro straps. There is no pinching
required.
7. Clip all valve clips to lock air for each strut. This will allow your struts to remain
inflated even if your LE loses air.
P 03
1 3 2 4
5
6
7
To Next Page
Loading...
