Machine
RELAUNCH
STEPS
1. When your kite crashes leading edge down, let the kite drift directly downwind
of you and make sure all lines have equal tension.
2. Pull your Oneline in using a hand over hand technique to bring the leading
edge towards you until your kite is lying on its back. You can secure this position
by cleating your Oneline in the Oneline trim cleat. Never wrap the Oneline
around your hand and pay special attention to keeping all body parts clear of
excess line.
P 08
3. Uncleat and release tension of the
Oneline and begin working your kite to
the side of the wind window by pulling
in one side of your bar. The amount of
Oneline you have already pulled in to get
the kite to flip over will slowly get pulled
back through the middle of the bar as the
kite gets closer to the edge of the wind
window.
1
2
3
To Next Page
Loading...
