Machine
CLIP & RIDE REBOOT
STEPS
P 05
1. Pull out some slack in the Oneline.
2. Loosen screw on Bell Housing and slide up the rope to expose the swivel.
3. Take the swivel end with the bend in it and insert it up into the loop in your
chicken loop.
4. Insert pin as shown.
5. Pull Bell Housing back over the swivel and line up the screw knob with the
black mark on the chicken rope. Secure the Bell Housing by tightening the
screw.
6. Check to make sure the Oneline
slides freely. Done.
1
2
3
4
6 5
To Next Page
Loading...
