INSTALLATION INSTRUCTIONS AND USER MANUAL FOR
SLOAN
®
EAF-700/750 GOOSENECK SERIES FAUCETS
Code No: 0816409
Rev. 3 (06/23)
SLOAN
®
LIMITED WARRANTY SUMMARY
Sloan Valve Company (“Sloan”), warrants its products against defects in materials and workmanship, excluding damage caused by matters beyond Sloan’s reason-
able control. Instructions for ling claims can be found in the Limited Warranty which can be obtained at www.sloan.com or by requesting a free copy by telephone at
888.756.2614. Sloan will repair or replace your defective product, or provide a refund, as your exclusive remedy. This is only a general summary of Sloan’s Limited
Warranty so it is important to note that the specic terms, conditions, limitations and exclusions, including the duration of warranty coverage for your particular Sloan
product, are contained in the actual Sloan Limited Warranty. The Limited Warranty is subject to applicable laws in your country, state, province or other jurisdiction—and
disputes arising under the Limited Warranty are to be resolved by binding arbitration unless you provide Sloan with an opt-out notice no later than 30 days after your
purchase date. In case of a conict with this summary, the terms and conditions set forth in the complete Limited Warranty will prevail.
PRIOR TO INSTALLATION
Prior to installing the Sloan Optima EAF-700 Series Faucets, install the
items listed below. Also, refer to rough-in illustrations.
• Lavatory/sink
• Drain Line
• Hot/Cold Water Supply Lines or Tempered Supply
IMPORTANT:
• ALL PLUMBING SHOULD BE INSTALLED IN ACCORDANCE WITH
APPLICABLE CODES AND REGULATIONS.
• FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS.
• KEEP THREAD SEALANT OUT OF YOUR WATERWAY TO PREVENT
COMPONENT PART DAMAGE! DO NOT USE ANY SEALANT ON
COMPRESSION FITTINGS.
Trim Plates
When the EAF Faucet is installed on a sink that has three (3) hole
punchings, a trim plate should be used. Trim Plates must be specied and
ordered separately.
SFP-11 Trim Plate for 4” (102 mm) Centerset Sink
SFP-22 Trim Plate for 8” (203 mm) Centerset Sink
TOOLS REQUIRED FOR INSTALLATION
• 13 mm open end wrench or nut driver for faucet retainer nut
• 5/8” open end wrench for female end of ex hose
Faucet Variations
-ISM Integral Spout Temperature Mixer
-PLG Plug-in Adapter power supply
(EAF-700)
-LT Less Transformer/Adapter
(EAF-700 Only) (Includes EAF-44
Power Splitter)
EAF-700/750 EAF-700/750-ISM