To Next PageTo Next PageWhat to do if my Sloan Plumbing Product does not flush?
If your Sloan Plumbing Product isn't flushing, the issue might be that the Control Stop or Main Valve is closed. To resolve this, simply open the Control Stop or Main Valve. Alternatively, a damaged Handle Assembly could be the culprit. In this case, replace the Handle (B-32-A or B-73-A) or install a Handle Repair Kit (B-50-A).
Why is the flush length too short on my Sloan REGAL XL?
If the length of the flush is too short on your Sloan Plumbing Product, ensure that the Diaphragm Assembly and Guide Assembly are hand-tight. If not, screw the two assemblies hand-tight. Also, an enlarged By-pass orifice from corrosion or damage can cause this issue, so install a new Inside Parts Kit to correct the problem. Another potential cause is an A-19-AU (Black) Urinal Relief Valve in a Closet flushometer; replace it with an A-19-AC (White) Closet Relief Valve. Additionally, check if an A-41-A Low Consumption Kit is installed in a non-Low Consumption fixture, and if so, replace it with the proper Inside Parts Kit. Finally, a damaged Handle Assembly can also lead to short flushes, so replace the Handle (B-32-A or B-73-A) or install a Handle Repair Kit (B-50-A).
How to fix a leaking handle on a Sloan Plumbing Product?
If your Sloan Plumbing Product handle is leaking, it might be due to a worn or damaged B-39 Handle Seal. To fix this, install a new B-39 Seal. Another cause could be a missing Handle gasket; install the Handle Gasket (A-31) or Sloan Handle Repair Kit (B-50-A). Finally, a worn Valve Handle Bushing can also cause leaks, so replace the Handle Repair Kit (B-50-A).
What to do if my Sloan REGAL XL closes off immediately?
If your Sloan Plumbing Product closes off immediately after flushing, it could be due to a ruptured or damaged Diaphragm. Install an Inside Parts Kit to correct this and update your Flushometer. Also, an enlarged By-Pass orifice from corrosion or damage can cause this, so installing an Inside Parts Kit will correct the problem.
Why is my Sloan REGAL XL making a chattering noise during flush?
If you hear a chattering noise during the flush of your Sloan Plumbing Product, the Inside Cover might be damaged. Replace the Inside Cover (A-71) to resolve this. Alternatively, the A-156-A Segment Diaphragm may have been installed upside-down. Reposition the Segment Diaphragm properly, referring to the markings on the Diaphragm.
General| ADA Compliant | Yes |
|---|---|
| Material | Brass |
| Flush Volume | 1.6 gpf |
| Valve Body Material | Brass |
| Finish | Chrome |
| Water Consumption | 1.6 gpf |
Lists the necessary tools for installing the Sloan Regal XL Flushometer.
Addresses common issues like no flush, insufficient volume, or immediate closure.
Lists available repair kits for Sloan Regal XL Flushometers based on flush volume.
