SMA 9000TL - Component Designation; Safety Precautions and Instructions; Intended Use and Compatibility

2 Safety
SMA Solar Technology AG
Replacement Manual CON-SMC9-11-RM-xx-10 7
1.7 Designation in the document
Complete designation Designation in this document
Power assembly (AST) AST assembly, AST, assembly
Operation control assembly (BFS) OCS assembly, OCS, assembly
AC/DC terminal assembly CON assembly, CON, assembly
Residual-current monitoring unit (RCMU) RCMU
2 Safety
2.1 Intended Use
The product must only be installed in the following SMA inverters:
Spare parts set Inverters
NR-SMC2TL-CON
NR3-SMC2TL-CON
SMC9000TL-10
SMC10000TL-10
SMC11000TL-10
NR-SMC3TL-CON
NR3-SMC3TL-CON
SMC9000TLRP-10
SMC10000TLRP-10
SMC11000TLRP-10
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the
intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal
or national laws, regulations or codes applicable to the installation, electrical safety and use of the
product. SMA Solar Technology AG assumes no responsibility for the compliance or non-
compliance with such laws or codes in connection with the installation of the product.
If the replacement and all activities stated in this document are carried out by persons who are not
qualified within the meaning of this documentation, this will void the guarantee and warranty claims
and in most cases terminate the operating permit. SMA Solar Technology AG shall not be held
liable for any damage caused directly or indirectly due to such changes by unauthorized persons.
ENGLISH