SMA AC-SPD STP 110-60 - Installing the AC-SPD Assembly; New Assembly Preparation

7 Installing the AC-SPD Assembly
SMA Solar Technology AG
Replacement Manual STPxxx-60-AC-SPD-RM-xx-10 17
10. Disconnect the six AC cables (AF10 or PH2) and
the control cable on the assembly.
11. Loosen the six screws of the assembly (PH1,
100mm). To do so, hold the assembly and loosen
the lower screws first. Then remove the assembly
sideways and downwards.
12. Install the new assembly (see Section7, page17).
7 Installing the AC-SPD Assembly
☐ The new assembly is compatible with the inverter (see Section2.1, page6).
Procedure:
1. Ensure that the square of black film is in the correct
position under the assembly and is not damaged. If
the film is damaged, remove it and add the film
provided in the same position.
ENGLISH