WARNING: For safety purposes, it is necessary to power off the installation before
proceeding with the physical installation.
Smappee physical installation
Install the Smappee Infinity according to the installation manual. Download the installation manual at
smappee.com/smappee-manuals. Do not start the configuration via the app yet!
In order to connect with a car charging station, make sure that:
• At least the following loads are measured with a CT (Check how to configure CTs in
section 5 and 8 of the Smappee Infinity manual).
o Grid
o Car charging station – Appliance
o Solar (if present)
• The Smappee Power Box is installed on the same electrical group as the charging station.
• The phase mapping of the Smappee Infinity is the same as the phase mapping of the
EVBox car charger.
• If you have a preconfigured Smart Charging kit, take notice of the stickers on the CTs
which indicate to which load they should be attached.
IMPORTANT: The following steps assume that the Smappee Infinity physical
installation has been completed. If this is not the case, please follow the
installation manual at smappee.com/smappee-manuals.
To Next Page
Loading...
