www.smartdigital.com.au
Edition 1.2
OPERATION
Powering ON the SmartBox
1. Ensure power cable is plugged into the mains connection on the front right hand side of the SmartBox top
panel,
2. Turn on the power switch located directly next to the mains connection to on or (I).
Powering ON the Blu-Ray/DVD player
1. Ensure power is switched on. The Samsung player has a touchscreen on the front. The On / Off button is
located on the right of this screen. See diagram below.
2. For further instructions – refer to DVD manual included.
Samsung Blu-Ray Player Front Panel
1. Remote Control Sensor
2. Power Button
3. Disc Slot
4. Display
5. Stop Button
6. Play/ Pause Button
7. Enter Button
8. Eject Button
9. USB Host
Connecting your Projector
1. Place your projector on the table next to your Smartbox, or on top of the Blu-Ray Player.
2. Plug HDMI cable into the HDMI out connection the rear of the Blu-Ray player (No. 3 on diagram),
inserting the other end into the HDMI in on the Projector
3. Plug your power cable into the rear of the projector, plugging the other end into a power source,
turning the power source on.
To Next Page
Loading...