www.smartdigital.com.au
Edition 1.2
Samsung Blu-Ray player rear panel
1. Antenna Out (to TV)
2. Antenna In
3. HDMI Out
4. Digital Audio Out (Optical)
5. LAN
6. Component Out
7. Video Out
8. Audio Out
Powering ON the Projector
1. Remove the lens cap.
2. Turn on the lamp by pressing “POWER” button either on the top of the projector or on the remote. The
Power LED will now turn Green.
3. The startup screen will display in approximately 10-15 seconds.
4. The projector will detect the source automatically. If it does not detect the DVD player, press the source
button until found. Repeat if necessary.
Adjustment of Zoom & Focus
You may turn the zoom ring to zoom in or out. To focus the image, rotate the focus ring until the image is clear. If
need be, adjust the height the projector using the tilt adjustment feet and the front and rear of the projector.
Note: for those with an EW610ST projector, there will not be a focus ring on the front of the projector as the
projector has a fixed lens.
Image Alignment
1. To align the image of the projector to your screen, use the zoom
function to get the image the correct size, and focus to get the
image clear.
2. Adjust the height of the projector using the feet of the Smartbox
HD to adjust to the correct height. If additional the image need to
come further up or down, prop up the front or back of the box
with a flat object to produce the desired image height.
3. Under ‘Display’ tab in the menu in adjust the vertical or horizontal
image shift to get the image precisely in the centre of the screen if
To Next Page
Loading...