Smart Digital Precision - Packing Up; Powering Off the Blu-Ray Player; Powering Off the Projector

To Next Page

To Previous Page

www.smartdigital.com.au

Edition 1.2

Laptop Audio Connection

3. Plug a mini jack plug into the headphones or line-out port of the laptop,

4. Connect the 6.5 mm jack plugs into AUX Input of the mixer.

Game Console

Game Console Video Connection

1. Connect video (Yellow) RCA cable into yellow video connection on the rear of projector and into your

game console

2. The projector should automatically select the correct input, otherwise press the Source button on top

of the projector

Game Console Audio Connection

3. Connect left and right audio (red & white) RCA cables into CD Tape Input on Mixer.

4. Using RCA connectors connect left and right audio (red & white) RCA cables to the rear of your game

console

5. Press CD tape to mix to enable audio, volume control is through the main mix audio

Microphone

1. Connect one end of an XLR cable to microphone end and other end of XLR cable directly into the

microphone input labeled on the mixer. Wired or wireless microphones can be connected.

PACKING UP

Powering OFF system

Powering OFF the Blu-Ray Player

1. Remove DVD or other media prior to switching off unit

2. Press the power button and wait to player to power down.

Powering OFF the Projector

1. Press the “POWER” button to turn off the projector lamp.

2. The following message will be displayed on the screen.

3. Press the “POWER” button again to confirm, otherwise the message will disappear after 15 seconds.

4. When you press the “POWER” button a second time, the system will show the countdown timer on the

screen.

5. The cooling fans continue to operate for about 10 seconds for cooling cycle. When the Power LED turns

Red, the projector has entered standby mode.

6. If you wish to turn the projector back on, you must wait until the projector has completed the cooling

cycle and has entered standby mode. Once in standby mode, simply press “POWER” button to restart the

projector.

7. Do not turn on the projector immediately following a power off procedure.

8. Remove HDMI cable from projector and Blu-Ray player and pack away in a secure transport case.