3
Purpose of the device and its functions
The device is designed for continuous measurement of electrical
network parameters and electricity consumption.
The device measures the following parameters:
• voltage, V
• current strength, A
• active power, W
• reverse * active power, rW
• active energy, Wh
• reverse * active energy, rWh
• Power factor
* parameters are available in the extended version of the device
Communication with the device is carried out via the IEEE 802.11
Wi-Fi 2.4 GHz wireless communication protocol.
The device transfers the accumulated data to the "cloud" server
for further analysis and visualization. For more information about
the processing capabilities of the data received from the device,
see the WEB page www.smart-maic.com.
Current data is also available on the built-in WEB site of the
device.
Controlled output
The device is equipped with a controlled dry contact output.
The controlled output is intended for automation of load control.
The output can control power solid-state relays to which
electrical appliances are connected, or for building automation in
low-current networks.
The output is controlled remotely, on the device's WEB page or
from the server. It is also possible to control the output according
to predefined conditions and / or schedule.
Thank you for purchasing the smart-MAIC 103 Energy Monitor.
This device allows you to measure and record changes in electricity
consumption and power grid parameters in three phases or three
lines in a single-phase network.
I. INTRODUCTION
To Next Page
Loading...
Need help?
General