SMART Joy S2 - Receiver Hardware; Receiver Panel Descriptions

Product Description
6
2.2 Receiver
2.2.1 Front Panel
No.
Description
1
Standby LED, lights red if the receiver is in Standby mode.
2
Signal-LED, lights green after the installation of programs is completed and a video signal is
routed to the TV set..

The green LED (light emitting diode) on the receiver front panel does not light
immediately after connecting the device to the power supply, but only after the
installation of programs is completed (either via RAPS or via program scan).
If you plug the power cord for the first time, the LED lights up only after instal-
lation. During later operation the receiver’s program list already exists; it takes
just a few seconds from inserting the power plug until you see the green LED.
2.2.2 Rear Panel
No.
Marking
Description
1
LNB IN
Connection for LNB (DVB-S)
2
SERVICE
Serial interface (RS232)
3
175 - 250 V ~, 50/60 Hz
Grid connection
4
TV
SCART connection for TV device
5
DIGITAL AUDIO
Digital RCA audio out (SPDIF)