SMART kapp iQ Pro 55 - Video

APPENDIX B
REMOTELY MANAGING THE INTERACTIVEFLATPANEL
61 smarttech.com/kb/171000
Use the following commands to assign source settings.
Command Possible values Response Standby
mode
set input [Value] =hdmi1
=hdmi2
=displayport
=ops/hdmi
=ops/displayport
=next
input=[Value] Yes
set videoinputdetect [Value] =ops/hdmi
=ops/displayport
=off
videoinputdetect=[Value] No
Video
Use the following commands to identify video settings.
Command Response Possible values Standby
mode
get displaymode displaymode=[Value] standard
user
dynamic
No
get contrast contrast=[Value] 0–100 No
get brightness brightness=[Value] 0–100 No
get tint tint=[Value] 0–100 No
get sharpness sharpness=[Value] 0–100 No
get colortemp colortemp=[Value] normal
warm
cool
user
No
get red red=[Value] 0–100 No
get green green=[Value] 0–100 No
get blue blue=[Value] 0–100 No
get blacklevel blacklevel=[Value] 0–100 No
get localdimming localdimming=[Value] on
off
No