SMART SPNL-6065-V2 - SPNL-6055 and SPNL-6065 Command Inventory; Power State

APPENDIX C
REMOTELY MANAGING THE DISPLAY
101 smarttech.com/kb/171167
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the contrast level by 5:
>set contrast +5
contrast=70
This example decreases the contrast level by 15:
>set contrast -15
contrast=55
SPNL-6055 and SPNL-6065 commandinventory
Power state
Use the following commands to identify power state settings.
Command Response Possible values Standby
mode
get intpowerstate intpowerstate=[Value] on
standby
dpms
novideo
confirm
proximitywait
welcome
Yes
get powerstate powerstate=[Value] on
off
standby
Yes
Use the following commands to assign power state settings.
Command Possible values Response Standby
mode
set powerstate [Value] =on
=off
=standby
powerstate=[Value] Yes