SMART SPNL-6065-V2 - Updating System Software; About System Software and Firmware Updates; Applying an Automatic System Software Update Manually

CHAPTER 4
CONFIGURING THE DISPLAY
39 smarttech.com/kb/171167
Content being shared Data rate transmission
Gaming or streaming video with major screen
changes
700 kb/sec–1.2 Mbps
Updating system software
When the display is connected to the Internet, it updates the system software and the firmware
automatically.
When the display is connected to the Internet, it updates its system software automatically.
About system software and firmware updates
When a system software update is available, the display downloads the update in the background
then waits for four hours of inactivity. When that happens, the display shows a two-minute
countdown before beginning the update. The countdown can be interrupted at any time. The
update begins when the countdown finishes. The display shows a blank screen for four minutes.
When the update is complete, the display shows the Whiteboard and any content that was on
Whiteboard before the update.
NOTE
You can configure your organization’s network to allow or prevent automatic system software
updates (see Configuring the display’s network connection on page33).
Applying an automatic system software update manually
If the display has downloaded the system software update but hasn’t yet applied the update, you
can start the update process manually from Settings.
To apply an automatic system software update manually
1.
Tap the Home button on the screen.
The launcher appears.
2.
Tap Settings .
The Settings window appears.
3. Scroll to Auto Update.
4. Under Check for Updates Now, tap Apply Update Now.