SMART SPNL-6065-V2 - SPNL-6265 P and SPNL-6275 P Command Inventory; Power State; SPNL-6065-V2, SPNL-6075, SPNL-6265-V2, SPNL-6275, SPNL-6065 P, SPNL-6075 P SPNL-6265 P and SPNL-6275 P Command Inventory

APPENDIX C
REMOTELY MANAGING THE DISPLAY
107 smarttech.com/kb/171167
Command Possible values Response Standby
mode
set lyncroom [Value] =reset lyncroom=[Value] No
set touchdetected [Value] =yes touchdetected=[Value] No
SPNL-6065-V2, SPNL-6075, SPNL-6265-V2,
SPNL-6275, SPNL-6065P, SPNL-6075P,
SPNL-6265P and SPNL-6275P
commandinventory
Power state
Use the following commands to identify power state settings.
Command Response Possible values Standby
mode
get intpowerstate intpowerstate=[Value] on
standby
dpms
novideo
confirm
proximitywait
welcome
Yes
get powerstate powerstate=[Value] on
off
standby
Yes
Use the following commands to assign power state settings.
Command Possible values Response Standby
mode
set powerstate [Value] =on
=off
=standby
powerstate=[Value] Yes