SMART U100 - Resolve Standby Mode Issues

U100 Troubleshooting Diagram
Back
Home
Projector is in standby
mode.
Bypass the ECP and use
the remote to power on the
projector. Is the issue
resolved?
Power cycle the unit. Is
the issue resolved?
Try another wall jack or
power cable, in the case
the wall jack is not
providing enough power. Is
the issue resolved?
Issue resolved.
Issue resolved.
Issue resolved.
No
No
Yes
Yes
Yes
For further
assistance, contact
SMART Technical
Support.
5.3 Projector is in standby mode
Revision History
Contact Support
Turn the projector ON using
the power button on the
projector. Does this resolve
the issue?
Replace battery for the
remote control.
Yes
No
No