DANGER
When handling batteries...
● Do not disassemble or modify the battery.
● Do not connect the positive and negative terminals
with any metal such as wire. Do not transport or store
batteries together with metallic objects.
● Do not heat batteries or directly expose them to fire .
● Do not drive nails into, strike with a hammer, or
step on the battery. Failure to observe the above could
result in battery leaks, heat emission, ignition, ruptur -
ing, skin burns or other injury.
WARNING
Keep the batteries out of the reach of small children.
If swallowed, poisoning or asphyxiation can result.
Seek a doctor's medical treatment immediately.
When handling batteries...
● Do not disassemble, modify, repair or charge the
battery. Do not combine old and new batteries.
● Observe the positive and negative polarity indica-
tions when inserting the batteries. ● Do not allow
dead batteries to remain in the battery compartment.
Failure to observe the above could result in batter y
leaks, heat emission, rupturing, skin burns or other
kind of injury.
If leaking occurs, do not allow battery fluid to come in
contact with the skin.
Doing so could result in skin burning. If battery fluid
gets on your skin or clothes, wash immediately with
water. If battery fluid gets in your eyes, flush with
water and seek medical treatment by a physician
immediately.
Use only the recommended batteries when replacing.
Failure to do so could result in battery leaks, heat
emission, rupturing, skin burns or other kind of injury.
CAUTION
Avoid using FlashPath near sources of heat or
flame.
Doing so could result in smoke or fire.
Do not immerse FlashPath in liquids such as
water, chemicals or oil.
Doing so could result in short circuiting, electric shock
or fire.
If bent,dropped or exposed to strong impact,
have the product inspected at the place of pur-
chase or contact us.
Failure to do so could result in smoke or fire.
Do not attempt to repair, modify or disassemble
FlashPath.
Doing so could result in fire, electric shock or injury.
Do not make direct contact with or touch the
pins (connecting surface) of SmartMedia with
metal objects.
Internal data could be damaged or erased by static elec-
tricity.
Do not turn the power off while uploading data
to or downloading data from SmartMedia.
Doing so could damage or erase the internal data.
20
DON’T
DO
DO
DON’T
C O N TAC T
DON’T
DON’T
DON’T
DON’T
DON’T
DO
DON’T
DISASSEMBLE
FP SDC-OEM.QXP 1/13/00 9:38 AM Page 21
To Next Page
Loading...