Smartgen APC715 - Page 14

APC715 Pump Unit Controller
APC715 Pump Unit Controller ISSUE 2013-08-28 Version 1.0 Page 14 of 62
★Commissioning
On load, off load or custom commissioning can be chosen. Custom commissioning
can configure on load or not during commissioning, when to commissioning and select
the mode after commissioning (manual mode, auto mode and stop mode).
★Clear users’ accumulation
Can clear User Acc. Run A, User Acc. Run B and Engine Acc. Run time.
Parameter setting including as following,
★Timer settings
★Engine settings
★Analog sensor settings (Engine temperature, engine oil pressure, fuel level, config.
1~6, outlet pressure)
★Input port settings
★output port settings
★GOV settings
★Pump settings
★Module settings
★Scheduling and maintenance settings
Example,
Return
>Start Delay
>Stop Delay
>Preheat Delay
>Cranking Time
> Crank Rest Time
> Safety On Time
> Start Idle Time
> Warming Up Time
> Cooling Time
> Stop Idle Time
> ETS Hold Time
Form1: Use to scroll settings,
to enter settings (form2), to
exit settings menu.
Timers >
Engine
Temp. Sensor
OP Sensor
Level Sensor
Config Sensor 1
Config Sensor 2
Config Sensor 3
Config Sensor 4
Config Sensor 5