Factory Reset
1) Gently pull the Set button at the bottom of the toggle out as far as it will go (about 1/8 inch) to remove
all power to X10 Toggle Dimmer Switch
The LED and the load will turn off
2) Wait 10 seconds, and then push the Set button in as far as it will go and hold until X10 Toggle Switch
beeps
A few seconds after you release the Set button, X10 Toggle Dimmer Switch will double-beep and
its LED and load will turn on
Specifications
View specifications for X10 Toggle Dimmer at: www.smarthome.com/X10WS467D.html
Troubleshooting
Problem Possible Cause Solution
After wiring in X10
Toggle Dimmer
Switch, the unit lets
out a continuous
beep.
X10 Toggle Dimmer
Switch is issuing an error
beep because the unit is
wired incorrectly.
Turn off the circuit breaker and try reinstalling X10
Toggle Dimmer Switch. If you are still experiencing
an error beep, consult an electrician to help you
install the switch.
Check the junction box wires to ensure all
connections are tight and no bare wires are
exposed.
Make sure the circuit breaker is turned on.
X10 Toggle Dimmer
Switch is not
controlling the load.
X10 Toggle Dimmer
Switch may not be getting
power.
Make sure the air gap (Set button) is not pulled
out.
X10 Toggle Dimmer
Switch and the controller
may be on opposite
phases.
Install an X10 signal bridge or coupler to bridge the
power line phases.
Move the other modules to different areas of your
home to reduce noise on the power line.
X10 Toggle Dimmer
Switch is not receiving
signals from X10
controllers.
Other modules may be
loading down the signal or
creating too much noise.
Install a noise filter between the X10 Toggle
Dimmer Switch and the noise-producing device.
X10 Toggle Dimmer
Switch turned on by
itself.
Stray X10 signals from a
neighboring system may
have triggered X10 Toggle
Dimmer Switch.
Install a power line signal blocker in your home to
keep X10 signals from other systems from
interfering.
The bulb filaments are vibrating. Use rough-service
130 Volt or appliance-grade bulbs to reduce the
noise.
The load is buzzing
when on or dim.
The dimming component
inside X10 Toggle Dimmer
Switch “chops” the power
line sine wave to reduce
the power.
Run X10 Toggle Dimmer Switch in the full-on
mode or switch to a non-dimming switch.
Page 8 of 9 X10WS467D Rev: 10/7/2011 6:25 PM
To Next Page
Loading...
General