smartmi E1 - How to Use the Air Purifier; On;Standby Operation; Switching Operating Modes; Wi-Fi Management

09
How to Use
On/Standby Switching mode
Press on/standby button to turn on the
purifier. When the purifier is on, press the
on/standby button to enter standby mode.
While the purifier is on, press the mode
switch button to cycle through modes.
Resetting Wi-Fi Factory Reset
While the purifier is on, press and hold
the mode button for 5 seconds, Wi-Fi
indicator blinking, Wi-Fi is successfully reset
and purifier enters the state of waiting for
connection.
While the purifier is on, press and hold Mode
button for 10 seconds, the mode indicator
and Wi-Fi indicator flash three times from
left to right in sequence, factory reset
completed.
Enabling/Disabling Wi-Fi
While the purifier is on, press and hold
the mode button and on/standby button
simutaniously for 5 seconds, the Wi-Fi will be
disabled. While Wi-Fi is o, same operation
can enable the Wi-Fi
.
Note: After factory reset performed, the filter life
span will be recalculated.
Level 3
Level 2
Level 1