2. Handlebars
a. Carefully unfold the handlebar stem post up into
its vertical position, then close the alloy lock lever
against the stem post. Finally rotate the plastic
safety lock ring until it enters and locks the alloy
lock lever closed.
b. Adjust the handlebar horizontal rotation if need-
ed by lifting up the handlebar stem quick release
lever, then twist the handle bar to the correct angle
and press the quick release lever down again to
lock.
Adjust the vertical height of handlebar using the
same procedure with the quick release lever down
on the mid section of the stem post.
2. Assembly Instructions
4. Seat
Release the seat post clamp lever and set the seat
post height to the position which is suitable for
you to comfortably reach the ground when you
are sitting on the bike, then refasten the seat post
clamp. The maximum height should be within the
max height markings on the seatpost.
3. Pedals
Attach the foldable pedals to the cranks, paying
attention to the “L” or “R” marked on the pedal
axles. Install washer and screw in the L pedal
counterclockwise and the right pedal clockwise. See
wellgo instructions for full details.
2. Assembly Instructions
e20 e20
Classic user manual.indd 10-11 7/15/2016 4:59:14 PM
To Next Page
Loading...
