SmartPool SmartKleen - Trouble-Shooting Guide

6
BBB>8,=?;::7.:8
SYMPTOM POSSIBLE REASONS SOLUTIONS
UNIT GOING BACK AND FORTH ONLY A FEW FEET
AT A TIME
Drive motor has water in it Replace Drive motor
Debris stuck in drive wheel Remove debris
UNIT NOT FUNCTIONING
Outlet not putting out proper voltage Check outlet voltage
Transformer not operating Check transformer output
Cord Defective Check Cord Voltage; Replace cord if needed
Outlet not putting out proper voltage Check outlet voltage
TRANSFORMER LIGHT OFF
Transformer may be operating but the light is not on. Test the unit with the transformer
Transformer not operating Check outlet voltage
UNIT MOVES BUT IT IS NOT PICKING UP DEBRIS
Pump motor malfunction, broken or jammed impeller Change pump motor, or replace or free impeller
UNIT IS CLIMBING OUT OF POOL
The pool does not have 2 feet of vertical slope for I
ncline sensor
Replace Filter Bag with new 8 hole bag
Incline sensor is defective Remove Pump motor and shake. If the unit continues to climb in spite of freed incline sensor,
Replace pump motor
UNIT MISSES AREAS OF POOL
Size of Pool is too big for unit Make sure the pool is less than 40 feet. If it is, reposition the power supply and rerun the unit.
Cord is tangled Straighten cord before and after each use.
UNIT HOVERING ON BOTTOM OF POOL
Filter bag clogged
Pump motor malfunction
Clean Filter Bag
Check Pump Motor
TROUBLE-SHOOTING GUIDE
!70,>0A4>4?BBB>8,=?;::7.:81:==0;,4=49>?=@.?4:9>