Average Value Symbol
The average value symbol is displayed when you press
the MEM button when power off. The latest 3 times
average value will be shown.
Pulse Rate Symbol
When the device detects the signal, the pulse rate
symbol on the display starts to ash.
8
2. Preparation
2.1 Battery Installation
1. Remove the battery cover as picture showed.
2. Insert 4 “AAA” batteries into the compartment and
To help ensure an accurate reading, follow these
directions:
Avoid eating, drinking alcohol or caffeine, smoking,
exercising and bathing for 30 minutes before taking a
measurement.
Rest for at least ve to ten minutes before taking the
measurement.
Stress raises blood pressure. Avoid taking measurements
during stressful times.
Measurements should be taken in a quiet place.
Remove tight-tting clothing from your arm.
Always measure on the same arm (normally left).
Take measurement regularly at the same time of every
day, as blood pressure changes even during the day.
1.2 Before Taking a Measurement
1.1 Display symbols
To Next Page
Loading...