The smaXtec Repeater has the following status LEDs (top left):
Power LED:
• Indicates if the smaXtec Repeater is switched on.
Link LED:
• Indicates the status of the connection in the wireless network (either to
another smaXtec Repeater or to the smaXtec Base Station).
Data LED:
• Indicates if data is being read out from smaXtec Sensors.
Power supply – mains adapter supplied
The smaXtec Repeater is powered by the mains adapter provided. For installation
purposes please only use this mains adapter. At the end of the cable there is a
specially constructed plug, which protects the smaXtec Repeater from water and
dust. Plug the connector into the socket on the left-hand side of the smaXtec
Repeater and tighten the screw cap. The mains adapter itself does not conform to an
IP standard with regard to protection against water, i.e. the mains adapter must not
be exposed to rain or moisture.
Image: Mains adapter (3 m/10 ft cable)
Specifications of the mains adapter:
• Manufacturer: SUNNY Computer Technology Europe, s.r.o.
• Input: 100-240 V ~, 0.5 A MAX, 50-60 Hz
• Output: 5 V --- 2.0 A
• Output power: 10 W MAX.
To Next Page
Loading...