7. This is the final screen when the Barricade is updated.
Part E – RESET of router to recover from lost password.
How do you reset the Barricade to factory defaults?
To reset your Barricade 7004-ABR to factory defaults please follow the steps below:
1. Power off the router for about 30 seconds and then turn it on.
2. Wait for the router to sync up (about 10 secs)
3. Depress the RESET
* button for 8 seconds and release it. To verify a sucessful
reset, the power light will flash rapidly, all 8 port lights will turn on shortly, and
then the router will return to its normal state.
* Note: The RESET button is located on the left side of the front panel.
Part F – Adjusting MTU Value.
MTU, Partial Loss of Internet Connection, and Performance
o MTU (Maximum Transmission Unit) is the largest packet a network
device transmits. The best MTU setting for equipment is often just the
default value. MTU is sometimes presented as something that can be
easily changed to improve performance, but in practice this may cause
To Next Page
Loading...
