• Password Settings
Use this menu to restrict access based on a password. By default, the password is
“smcadmin”.
NOTE: Passwords can contain up to 9 alphanumeric characters and are case sensitive.
• Remote Management
This feature allows a remote PC to configure, manage, and monitor the Barricade using a
standard web browser.
1. Check “Enable”
2. Set the “Allow Access” policy to one of the 2 options:
o Any IP Address – you can remotely manage the Barricade from any IP address on
the WAN side.
o
Single IP – you can only remotely managed the Barricade from this IP address on
the WAN side.
o IP Range – you can remotely manage the Barricade from any IP address in this
range.
3. Set the Remote Management Port to the port through which you want to remotely
access the Barricade.
NOTE: Do not set this for a port that is already in use. For example, if you are running
a web server on port 80, you can’t set the remote admin port to 80.
To Next Page
Loading...
