Configuring the Wireless Barricade g Router
34
Password Settings
For security you should assign your own password before
exposing the Wireless Barricade to the Internet.
(Default: smcadmin)
Passwords can contain from 3 to 12 alphanumeric characters
and are case sensitive.
Note: If your password is lost, or you cannot gain access to
the user interface, press the Reset button on the rear
panel (holding it down for at least five seconds) to
restore the factory defaults.
Enter a maximum Idle Time Out (in minutes) to define a
maximum period of time for which the login session is maintained
during inactivity. If the connection is inactive for longer than the
maximum idle time, it will perform system logout, and you have to
log into the web management system again.
(Default: 3 minutes)
To Next Page
Loading...
