To Next Page
B
Brenda JamesJul 31, 2025
What to do if the Link/Act LED is off when a device is connected to the corresponding port on SMC Networks EZ Switch SMCFS801P?
- BbgoodmanJul 31, 2025
If the Link/Act LED is off when a device is connected to the corresponding port on your SMC Networks Network Hardware, ensure the cable connectors are firmly plugged into both the switch and the device. Also, verify that the connected device is turned on and working correctly. The cable should be less than 100 meters long. Finally, inspect the port on the attached device and cable connections for any defects, replacing the cable if necessary.
General