10
8. Unpacking
1. Unpack and check all items against the packing list in section 7. In the very unlikely event
that anything is missing your dealer and SME Limited should be notified at once.
2. The design of the turntable allows it to be used on any substantial table or similar piece of
furniture in the absence of a dedicated equipment stand.
3. Lift the motor side of the turntable and remove the Motor Transit Screw from the underside
of the base immediately below the motor.
4. Remove the two packing strips from the sides of the motor.
5. The turntable is packed with only a little oil in the bearing housing and this should now be
filled. A metered charge is provided in Syringe Part No: 1287.
6. Remove the syringe from its packing and insert the tip into the Oil Filler Adaptor, which
will be found already fitted to near the spindle. (see diagram)
7. Slowly inject the complete quantity into the bearing maintaining downward pressure
throughout the operation to prevent leakage.
8. Remove the syringe and dispose of it responsibly!
9. Unscrew and remove the Oil Filler Adaptor using the Box Spanner Part No: 1946. Retain
the adaptor for possible future use
10. The suspension is secured for transit by two screws; these are accessible through holes in
the driven pulley, using the 4mm A/F hexagon wrench. The two packing strips can now
also be moved from the underside of the driven pulley.
To Next Page
Loading...
Need help?
General
