User instructions
18
INTERRUPTION A PROGRAM
To interrupt a program in progress:
• press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
• you may now restart the program by pressing button (3) again until it
restarts, or change or annul the program (see "C
HANGING A
PROGRAM
", or "ANNULLING A PROGRAM").
CHANGING
A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “INTERRUPTION A PROGRAM”);
• select the new program;
• start the program (see “S
TARTING THE PROGRAM”).
ANNULLING A PROGRAM
To annul the program
• press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
• Keep the START/PAUSE button (3) pressed until the PROGRAM
PHASES lights (5) go out (confirmation beep). The lights of
programs 4 and 5 come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted. When the operation is complete, the
PROGRAM PHASES lights (5) flash.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “STARTING THE PROGRAM”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
To Next Page
Loading...
