Problem and alarm code Possible cause and solution
The temperature of the water in‐
side the appliance is too high or
malfunction of the temperature
sensor occurred.
The display shows i61 or i69.
• Make sure that the temperature of the inlet water does not exceed
60°C.
• Switch the appliance off and on.
Technical malfunction of the ap‐
pliance.
The display shows iC0 or iC3.
• Switch the appliance off and on.
The level of water inside the ap‐
pliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height above
the floor. Refer to the installation instructions.
The appliance stops and starts
more times during operation.
• It is normal. It provides optimal cleaning results and energy savings.
The programme lasts too long. • If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
• Activating options can increase the programme duration.
The displayed programme dura‐
tion is different than the duration
in the consumption values table.
• The pressure and the temperature of the water, the variations of the
mains supply, the options, the quantity of dishes and the degree of
soil can change the programme duration.
The remaining time in the display
increases and skips nearly to the
end of the programme duration.
• This is not a defect. The appliance is working correctly.
Small leak from the appliance
door.
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if
applicable).
The appliance door is difficult to
close.
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• Parts of the tableware are protruding from the baskets.
The appliance door opens during
the wash cycle.
• The Dry Assist function is activated. You can deactivate the function.
Refer to "Settings".
Rattling or knocking sounds from
the inside of the appliance.
• The tableware is not properly arranged in the baskets. Refer to bas‐
ket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-
beaker.
• The amperage is insufficient to supply simultaneously all the appli‐
ances in use. Check the socket amperage and the capacity of the
meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Serv‐
ice Centre.
ENGLISH 23
To Next Page
Loading...
