Smeg SFA106N - Pyrolytic Cleaning Cycle

Cleaning and maintenance
40
4.6 Pyrolytic (on some models only)
Preliminary operations
Before starting the Pyrolytic cycle:
• Clean the internal glass panel following
the usual cleaning instructions.
• For very stubborn encrustations spray an
oven cleaning product onto the glass
(read the warnings on the product);
leave for 60 minutes, then rinse and dry
the glass using kitchen roll or a microfibre
cloth.
• Completely remove all accessories from
inside the oven.
• Remove the rack/tray support frames.
• Close the door.
Setting the Pyrolytic cycle
1. Press and turn the function knob to
select the Eco Pyrolytic or Pyrolytic
function.
2. The duration of the Pyrolytic cycle will
appear on the display.
3. Press and turn the programming knob to
set the duration of the Pyrolytic cycle
from a minimum of 2 hours to a
maximum of 3 hours (except for the
function, the duration of
which is 2 hours).
4. Press the programming knob to confirm
the parameters entered.
5. Press the function knob to start the
pyrolytic cycle.
The pyrolytic cycle is an automatic
high-temperature cleaning
procedure which causes dirt to
dissolve. Thanks to this process, it is
possible to clean the oven cavity
very easily.
Improper use
Risk of damage to surfaces
• Remove any food residues or large spills
from previous cooking operations from
the oven cavity.
• Switch off the burners or hot plates of the
cooktop installed above the oven.
Recommended pyrolytic cycle
duration:
• Light dirt: 2 hours.
•Medium dirt: 2 ½ hours.
• Heavy dirt: 3 hours.