Cleaning and maintenance
31
EN
Removing racks/trays support frames
Removing the guide frames enables the
sides to be cleaned more easily. This
operation should be performed each time
the automatic cleaning cycle is used (on
some models only).
To Remove the guide frames: Pull the guide
frames towards the inside of the oven so as
to remove it from groove A, then unhook it
from the seats B on the back.
When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
On pizza models only:
Remove in sequence the pizza plate cover
(1) and the base (2) on which it is placed.
The base has to be lifted a few millimetres,
then pulled outwards.
Lift the end of the bottom heating element
(3) a few centimetres and clean the oven
base.
Put the pizza plate base back in place,
pushing it in until it hits the back of the oven,
and push it down so that the heating
element plate is embedded into the base
itself.
To Next Page
Loading...
