Cleaning and maintenance
20
4. Clean the external glass panel and the
panels removed previously. Use
absorbent kitchen roll. In case of
stubborn dirt, wash with a damp sponge
and a neutral detergent.
5. Refit the panels in the reverse order in
which they were removed.
6. Reposition the internal glass panel. Take
care to centre and secure the 4 pins into
their seats in the oven door by applying
slight pressure.
Removing rack/tray support frames
Removing the rack/tray support frames
enables the sides to be cleaned more
easily. This operation should be performed
each time the automatic cleaning cycle is
used (on some models only).
Removing the rack/tray support frames:
1. Pull the frame towards the inside of the
oven cavity to unhook it from its
groove A.
2. Then slide it out of the seats on the
back B.
3. When cleaning is complete, repeat the
above procedures to replace the rack/
tray support frames.
To Next Page
Loading...
Need help?
General
