2. Grasp the door on both sides with both
hands, raise it so that it forms an angle of
around 30° and remove it.
3. To replace the door, insert the hinges in
the relative slots in the appliance, making
sure that the grooved sections A are
resting completely in the slots. Lower the
door and once it is in place, remove the
pins from the holes in the hinges.
4.4 Cleaning the door glazing
The glass in the door should always be kept
thoroughly clean. Use absorbent kitchen
roll. In case of stubborn dirt, wash with a
damp sponge and an ordinary detergent.
Removing the internal glass panels
For easier cleaning, the internal glass
panels of the door can be removed.
1. Remove the internal glass panel by
pulling the rear part gently upwards,
following the movement indicated by the
arrows (1).
2. Then, pull the front part upwards (2). In
this way, the 4 pins attached to the glass
are released from their seats in the oven
door.
3. Some models have an intermediate glass
panel. Remove the intermediate glass
panel by lifting it upwards.
To Next Page
Loading...
Need help?
General
