8. BASIC SETTINGS
You can configure the appliance by changing
basic settings according to your needs.
Num‐
ber
Settings Values
Description
1)
1
Water hardness 1L - 10L Adjust the level of the water softener according to
the water hardness in your area.
Factory setting: 5L.
2
Rinse aid empty
notification
1d (on)
0d (off)
Activate or deactivate the rinse aid indicator.
Factory setting: 1d.
3
End sound 1b (on)
0b (off)
Activate or deactivate the acoustic signal for the
end of a programme.
Factory setting: 0b.
4
Auto door open 1o (on)
0o (off)
Activate or deactivate the Dry Assist.
Factory setting: 1o.
5
Key tones 1F (on)
0F (off)
Activate or deactivate the sound of the buttons
when pressed.
Factory setting: 1F.
6
Latest pro‐
gramme selection
1H (on)
0H (off)
Enable or disable the automatic selection of the
most recently used programme and options.
Factory setting: 0H.
1)
For more details, refer to the information provided in this chapter.
You can change the basic settings in setting
mode. Instructions on how to configure the
appliance are provided further in this chapter.
When the appliance is in setting mode, the
display shows a digit and a letter. For each
setting, a dedicated letter is displayed. The
dedicated letters are indicated in the table.
The order of the basic settings presented in
the table is also the order of the settings in
setting mode.
8.1 Setting mode
How to navigate in setting mode
You can navigate in setting mode using
programme buttons.
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between
the basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
ENGLISH 11
To Next Page
Loading...
Need help?
General
